# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

#If you want to use HDMI instead of DSI,
#DSI display autodetection is disabled by default on these boards. To enable detection, add the following line to /boot/config.txt:
##1
#display_default_lcd=0

#pouzit HDMI namiesto 7" LCD  napis  1

ignore_lcd=0
#ignore_lcd=1

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
##3
#hdmi_drive=2
#hdmi_mode=82


# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
force_turbo=1
arm_freq=1200
core_freq=250


# Uncomment some or all of these to enable the optional hardware interfaces
#dtparam=i2c_arm=on
#dtparam=i2s=on
#dtparam=spi=on

# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
dtparam=audio=on


#audio quality
audio_pwm_mode=2
#dtparam=audio=on
gpu_mem=256


# -uncomment for composite PAL
#sdtv_mode=0   # Normal NTSC
#sdtv_mode=1   # Japanese version of NTSC – no pedestal
#sdtv_mode=2   # OK  Normal PAL
#sdtv_mode=3   # Brazilian version of PAL
#sdtv_aspect=1 # 4:3
#sdtv_aspect=2 # 14:9
#sdtv_aspect=3 # 16:9

# disable rainbow splash
#disable_splash=1